Czech

5

Not applicable.

The basic knowledge of engineering technology, the knowledge of secondary school mathematics and the bases of statistics.

The course-unit credits award is based on attendance at seminars, correct elaboration of computational assignment and active participation in its processing.
The final exam will be composed of written and oral part. It is graded on the ECTS grading scale.
Attendance at lectures is voluntary, however recommended. In case of regularly apologized student’s absence in the laboratory practice, the student may attend the laboratory practice together with other student team if
agreed with the lecturer, or again in case of an apologized absence to participate in the alternative laboratory practice at the end of the semester.

Familiarize the students with concepts in metrology and with techniques in correlation to measurement and measurement methods.
Theoretical knowledge in metrology obtained in the lectures. Practical knowledge of measurement obtained in exercies, elaboration of measured variables in compliance with geometrical requirements on the products (GPS).

Not applicable.

Not applicable.

BUCHER, Jay L. The Metrology Handbook. 2nd ed. Milwauke, Wis: ASQ Quality Press, 2012. ISBN 978-087-3898-386. (EN)
DRBÚL, M., ŠAJGALÍK, M. a kol. Strojárska metrológia a kvalita povrchov vytvorených technológiami obrábania. Žilina: Žilinská univerzita v Žiline, 2014, ITMS 22410320051. (CS)
Balasubramanian Muralikrishnan and Jayaraman Raja. Computational Surface and Roundness Metrology. Berlin: Springer, 2009. ISBN: 978-1-84800-296-8. (EN)
Gao, W. Metrology. Berlin: Springer, 2019. ISBN 978-981-10-4939-2. (EN)
CURTIS, Mark A. and Francis T. FARAGO. Handbook of dimensional measurement. Fifth edition. South Norwalk: Industrial Press, 2014. ISBN 978-0-8311-3465-5. (EN)
MITRA, Amitava. Fundamentals of Quality Control and Improvement, 4th Edition. 4. vydání. USA: WILEY, 2016. ISBN 978-1-118-70514-8. (EN)
SIMMONS, Colin, Dennis MAGUIRE and Neil PHELPS. Manual of Engineering Drawing. 5. vydání. GB: Butterworth-Heinemann, 2020. ISBN 978-0-12-818482-0. (EN)

SUGA, N. Metrology Handbook: The Science of Measurement. 1st. edition. Mitutoyo (UK) Ltd., 2007. 260 p. ISBN-13: 978-0955613302. (EN)

eLearning: currently opened course

26 hours, compulsory

1.Safety in the laboratory, assignment of laboratory measurements, requirements for reports
2.Software for measurement process control
3.Statistical evaluation of the measurement, calibration of measuring tools
4.Design of manual coordinate measuring machines (CMM), preparation of a measurement plan/ Design of an optical profiler, preparation of a sample for measurement
5.Design of an optical profiler, preparation of a sample for measurement/Design of manual coordinate measuring machines (CMM), preparation of a measurement plan
6.Calibration of stylus, levelling/ Measurement preparation, levelling the analyzed surface
7.Measurement preparation, levelling the analyzed surface/ Calibration of stylus, levelling
8.Measurement of geometric elements with a manual CMM/ 3D (topographic) measurements of surfaces
9.3D (topographic)measurements of surfaces/ Measurement of geometric elements with a manual CMM
10.Analysis of dimensions, shape and position of elements/ Calculation and analysis of surface texture parameters
11.Calculation and analysis of surface texture parameters/ Analysis of dimensions, shape and position of elements
12.Creation of sub-programs in CNC mode/ Calculation of 3D surface texture parameters
13.Calculation of 3D surface texture parameters/ Creation of sub-programs in CNC mode

eLearning: currently opened course