Detail publikace

The production optimization of steel impellers by using of the electron beam welding method

HAVLÍK, P. KOUŘIL, J. VÁLKA, L. DLOUHÝ, I. CHALUPNÍK, P.

Originální název

The production optimization of steel impellers by using of the electron beam welding method

Typ

článek ve sborníku ve WoS nebo Scopus

Jazyk

angličtina

Originální abstrakt

Due to the continuous development in the production of high-quality impellers, especially regarding the shape of the flow-through channel which defining the parameters of the compressor stages, a combination of machining and welding can be used to increase productivity and reduce the cost of impeller production. Just the electron beam welding (EBW) is suitable method for mass production of not only impellers. A distinct benefit of the EBW method is minimal thermal influence on the welded material and precise control of the entire process. The weld quality when using EBW depends on the correct setting of process parameters, welded material and weld joint design. The combination of these parameters affects the stability of emerging keyhole when the electron beam (EB) is incident on the welded material. Instability is caused by rapid changes of the temperature and pressure inside the keyhole that lead to closure of the keyhole by molten material and the subsequent formation of weld defects. The whole process thus requires the comprehensive solution including both structural and material characteristics.

Klíčová slova

electron beam welding; impeller; steel; weld design

Autoři

HAVLÍK, P.; KOUŘIL, J.; VÁLKA, L.; DLOUHÝ, I.; CHALUPNÍK, P.

Vydáno

18. 6. 2019

Nakladatel

TISK AS, s.r.o.

Místo

Jaroměř

ISBN

978-80-87583-30-2

Kniha

Technological Forum 2019 - Book of Proceeding

Edice

1.

Strany od

235

Strany do

241

Strany počet

7

BibTex

@inproceedings{BUT157707,
  author="Petr {Havlík} and Jan {Kouřil} and Libor {Válka} and Ivo {Dlouhý} and Petr {Chalupník}",
  title="The production optimization of steel impellers by using of the electron beam welding method",
  booktitle="Technological Forum 2019 - Book of Proceeding",
  year="2019",
  series="1.",
  pages="235--241",
  publisher="TISK AS, s.r.o.",
  address="Jaroměř",
  isbn="978-80-87583-30-2"
}