Detail publikace

Analysis of the machinability of copper alloy Ampcoloy by WEDM

MOURALOVÁ, K. BENEŠ, L. PROKEŠ, T. BEDNÁŘ, J. ZAHRADNÍČEK, R. JANKOVÝCH, R. FRIES, J. VONTOR, J.

Originální název

Analysis of the machinability of copper alloy Ampcoloy by WEDM

Typ

článek v časopise ve Web of Science, Jimp

Jazyk

angličtina

Originální abstrakt

The unconventional technology wire electrical discharge machining is widely used in all areas of industry. For this reason, there is always an effort for efficient machining at the lowest possible cost. For this purpose, the following comprehensive study has been carried out to optimize the machining of the copper alloy Ampcoloy 35, which is particularly useful in plastic injection moulds. Within the study a half-factor experiment of 25-1 with 10 axial points and 7 central points of a total of 33 rounds was carried out, which was focused on the response monitoring of the input factors in the form of the machine parameters setup: gap voltage, pulse on time, pulse off time, discharge current, wire speed. Based on the study of the response in the form of cutting speed and surface topography, their statistical models were created, while the optimal setting of machine parameters was determined to maximize the cutting speed and minimize the topography parameters. Further, a detailed cross-sectional analysis of surface and subsurface layer morphology was performed using electron microscopy including the chemical composition analysis. In order to study microstructural changes in the material at the atomic level, a lamella was created, which was then studied using a transmission electron microscope.

Klíčová slova

WEDM; electrical discharge machining; Ampcoloy; design of experiment; machining parameters

Autoři

MOURALOVÁ, K.; BENEŠ, L.; PROKEŠ, T.; BEDNÁŘ, J.; ZAHRADNÍČEK, R.; JANKOVÝCH, R.; FRIES, J.; VONTOR, J.

Vydáno

11. 2. 2020

Nakladatel

MDPI

Místo

Švýcarská konfederace

ISSN

1996-1944

Periodikum

Materials

Ročník

13

Číslo

4

Stát

Švýcarská konfederace

Strany od

1

Strany do

14

Strany počet

14

URL

Plný text v Digitální knihovně

BibTex

@article{BUT162122,
  author="Kateřina {Mouralová} and Libor {Beneš} and Tomáš {Prokeš} and Josef {Bednář} and Radim {Zahradníček} and Róbert {Jankových} and Jiří {Fries} and Jakub {Vontor}",
  title="Analysis of the machinability of copper alloy Ampcoloy by WEDM",
  journal="Materials",
  year="2020",
  volume="13",
  number="4",
  pages="1--14",
  doi="10.3390/ma13040893",
  issn="1996-1944",
  url="https://www.mdpi.com/1996-1944/13/4/893"
}